
CFN III Quick Reference
MDE-4483 CFN III Quick Reference Guide v3.3 · August 2005 Page 39
Address 7 8 9 10
1 cl cl cl cl
2 cl cl cl op
3 cl cl op cl
4 cl cl op op
5 cl op cl cl
6 cl op cl op
7 cl op op cl
8 cl op op op
9 op cl cl cl
10 op cl cl op
11 op cl op cl
12 op cl op op
13 op op cl cl
14 op op cl op
15 op op op cl
16 op op op op
Jumpers
Jumper Function and/or
Normal Setting
Setting(*=customary)
K1 Jumpered=debug *always open
K2 Watchdog timer
*1-2=on (always)
2-3=off
K3 ---- *open, future use
K4, K5
Position 1-2=AM MAG
Position 2-3=Omron
reader
Test Mode
To activate test mode, open the island card reader
door, flip the S3 switch on the CPU board to TEST,
and press START OVER on the keypad. (The unit
must remain open during tests.) The keypad is now
enabled for selecting one of the 9 test routines:
1 test front panel lights for paper low and paper
out on receipt printer
2 test the table messages
3 test printer
4 test DES
5 test alphanumeric display
6 test keypad
7 test card reader (mag or optical)
8 display baud rate and address
9 test paper cutter
Printers
Star
There are two DIP switch banks on the Star printer.
Each position must be set as follows:
DIP Switch Bank 1
Position & Definition Required Setting
1-3 9600 baud on
4 stop bit 1 on
5 X-on/X-off mode off
6 8 data bits on
7 no parity on
8 even parity off
DIP Switch Bank 2
Position & Definition Required Setting
1 USA character set on
2 USA character set on
3 printer type on
4 CR valid off
DPT
The Tokheim DPT comes in two models: TCS and
Premier.
Keypad
The keys on the TCS and Premier DPT keypads can
be configured for different functions with the
Tokheim DPT/Gilbarco CRIND keyboard layout on
page 4 of the CFN3’s SYS_PAR program. The
characters that select different functions are shown
below. Note that these characters are case-sensitive:
Char. Function
0-9 Numeric digits 0 through 9
. Decimal point
E ENTER
C CLEAR
Y Yes
N No
$ Cash inside
c Cash outside
Komentarze do niniejszej Instrukcji