Gasboy Current Loop Driver Ferrite Instrukcja Użytkownika Pobierz pdf

MDE-4707 Current Loop Driver Ferrite Installation Instructions · September 2007 Page 1

Introduction

Purpose

This document is shipped when you order one of the following:

• Current Loop Driver Unit - CFN (C05688)

• Cable (CRIND) & Adaptor (C06326)

Overview

To comply with FCC requirements, the Current Loop Driver Unit requires one Transient

Suppressor or Ferrite (Q11433-112) on each of the RS-422 cables connected to the unit. There

could be one or two RS-422 cables (CRIND Port, SC Port), depending on the site

configuration (see

Figure 1).

Table of Contents

Topic Page

Introduction 1

Important Safety Information 2

Installation of the Ferrite 4

Warranty

For information on warranty, refer to MDE-4255 Gasboy’s Warranty Policy Statement. If you

have any warranty-related questions, contact Gasboy’s Warranty Department at its Greensboro

location.

MDE-4707

Current Loop Driver Ferrite

Installation Instructions

September 2007

1 2 3 4

MDE-4707 Current Loop Driver Ferrite Installation Instructions · September 2007 Page 1IntroductionPurposeThis document is shipped when you order one

MDE-4707 Current Loop Driver Ferrite Installation Instructions · September 2007 Page 2Important Safety InformationImportant Safety InformationThis se

Important Safety InformationPage 3 MDE-4707 Current Loop Driver Ferrite Installation Instructions · September 2007 No Open Flames Open flames from

Brak uwag

Gasboy Current Loop Driver Ferrite Instrukcja Użytkownika