Gasboy Atlas Single Std. Inlet Centering Kit Instrukcja Użytkownika Pobierz pdf (Strona 5)

MDE-4637A Single Standard Pump/Dispenser Inlet Centering Kit (M07676K00X) Installation for Atlas™ Units · August 2007 Page 5

Installation of the Kit

Note: The M07676K00X kits are installed at the time of initial unit installation. If the kits are

to be retrofitted onto units that are already in use, consult and follow MDE-4334 Atlas

Start-up/Service Manual for safety, purging, and shut-down procedures.

Installing the M07676K001 Kit on a Dispenser

To install the M07676K001 kit on a dispenser, proceed as follows:

1 Attach the manifold blanking spacer (M07671B001) to the underside of the existing inlet

support plate. Secure it with three flanged screws (M00415B016) and tighten.

2 Lightly apply grease to the bottom faces of both the blanking spacer and the existing dispenser

inlet casting.

3 Lightly apply some grease to both discharge flanges of the inlet manifold (M05347B010).

4 Attach the two gaskets (M06101B001) to the flanges in the mating position.

5 With gaskets in place, attach the manifold to the dispenser inlet casting and secure using three

lockwashers (M01071B001) and three socket head screws (M04973B005). Tighten the screws

to a snug fit; do not overtighten.

6 Secure the opposite end of the manifold to the manifold blanking spacer using three

lockwashers (M01071B001) and three socket head screws (M04973B005).

7 Tighten all the six screws that attach the manifold to the inlet casting and blanking spacer.

8 Check for leaks upon initial operation of the unit.

Existing Single

Dispenser Inlet

Casting

Inlet Manifold

(M05347B010)

M10 X 25 Socket Head

Screw (M04973B005)

M10 Lock Washer

(M01071B001)

Gasket

(M06101B001)

Dispenser Manifold

Blanking Space

(M07671B001)

Existing

Dispenser Inlet

Support Plate

M6 X 25 Flanged

Screws

(M00415B016)

1 2 3 4 5 6 7 8

Brak uwag

Gasboy Atlas Single Std. Inlet Centering Kit Instrukcja Użytkownika Strona 5