Gasboy CFN Series Unitec PC Interface Instrukcja Użytkownika Pobierz pdf (Strona 11)

MDE-4695 CFN Series Unitec® PC Interface for Site Controller III Version 3.6 and Later · July 2010 Page 7

Cable Connections Cable Connections and Software Installation

3 – Cable Connections and Software Installation

Cable Connections

An RS-232 Cable (see Figure 3-1) is connected from one of the SC III PC ports to the DB9S

port on the Unitec box.

Figure 3-1: RS-232 Cable Connection to the Car Wash Controller

SC III

Car Wash Controller

Q13180-20

Q13850-15

Q13180-17

Software Installation

To install the software, proceed as follows:

1 Log on as administrator.

2 If SC III is running, press Alt and X to shut down the site and end the session.

3 Insert the Car Wash Interface disk into the disk drive.

4 Select Start > Run > A:\install from the taskbar, to run the installation program from the

interface disk. The prompt message, “Are you connecting a Unitec Car Wash to any COM

port?” appears.

5 Press Y for “Yes”.

6 Enter the COM port number when prompted.

7 Edit the parameter file to match your site setup, when prompted by the installation program.

Note: You can edit this file later in the “XBIN” directory, if required.

8 At the next “Enter COM port number” prompt, press Enter to end the program.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Brak uwag

Gasboy CFN Series Unitec PC Interface Instrukcja Użytkownika Strona 11